agriculture Equipment
Would you like to react to this message? Create an account in a few clicks or log in to continue.

The Thrust ball bearings

Go down

The Thrust ball bearings Empty The Thrust ball bearings

Post  landoo Tue May 04, 2010 1:03 am

Thrust ball bearings consist of two precision chrome steel washers (ring) and a ball complement spaced by bronze retainer. They can be supplied with or without radius ball grooves in the rings. Thrust ball bearings are used under purely axial loads.

Thrust ball bearings are used under purely axial loads.Thrust ball bearings can handle loads in the axial direction only. Bearing rings mounted on the shaft are called shaft washers, and those mounted in the housing are called housing washers. Both washers contain raceways for the balls. Thrust ball bearingsare available as both single and bi-directional types. The bi-directional thrust bearing incorporates a third washer and an additional set of balls. This center washer is located in the axial direction by a shaft shoulder and sleeve.Care must be taken in handling to prevent damage to the separable rings and ball assemblies.
When used on a horizontal shaft, a minimum axial load must be applied. Pressed steel plate, polyamide resin, machined high-strength brass or mild steel are used for cages. Care must be taken in handling to prevent damage to the separable rings and ball assembly.

landoo

Posts : 128
Join date : 2010-04-30

Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum